At a glance

  • Panel capacity, annual generation and electricity used on site measure different things.
  • The calculator’s 5.5 sun-hour starting value is an editable screening assumption, not a measurement of your roof.
  • A proposal should explain the yield source, losses, daytime demand and connection assumptions.

A solar estimate is easier to judge when you keep three numbers separate: the size of the panels, the electricity they could generate, and the electricity your guesthouse could use. The last of those is central to the savings case.

Our calculator helps start that conversation. It cannot see your roof, read your bills or confirm your island’s connection conditions. Treat its result as a way to compare assumptions before a site-specific proposal.

Start with the units

kWp is rated panel capacity. It describes the array’s peak rating under specified test conditions. kWh is energy: the quantity generated or consumed over a period. A capacity figure by itself does not tell you how many units will appear on a bill.

kWh/kWp is specific yield. The Global Solar Atlas FAQ explains this as the electricity a system could generate for each unit of installed peak capacity. Check whether a quoted yield covers a day or a year before multiplying it by the proposed size.

Read the starting example correctly

In the calculator’s peak-sun-hours mode, the starting calculation is 5.5 hours × 365 days × 80% assumed system performance. That gives 1,606 kWh per kWp per year. For an illustrative 20 kWp array, it becomes 32,120 kWh of estimated first-year generation.

These are arithmetic examples from our chosen starting inputs, not recorded Maldives project results. The 5.5 value represents an equivalent daily solar resource for this simplified method; it is not a promise of 5.5 hours at full output every day. Both the resource and performance inputs can be changed.

The alternative regional-atlas mode uses an annual specific-yield value directly. Do not apply the peak-sun-hours performance multiplier again to that already-modelled value. Ask which method a supplier has used so two estimates are compared on the same basis.

Your roof changes the estimate

Regional data gives a starting point. The Global Solar Atlas guide describes its results as introductory data and notes that project-specific factors require more detailed analysis. A long-term average also cannot predict the weather in a particular month.

A design should record roof layout, orientation, tilt and shading, then explain how equipment and other losses were treated. The official PVWatts calculator, for example, distinguishes loss categories such as dirt, shading, wiring and availability. We are not claiming that our simple calculator runs PVWatts or reproduces its modelling.

For your enquiry, photographs taken from a safe accessible location and any existing roof information are useful. A survey can establish what space is actually usable and what needs checking before equipment is ordered.

Generation becomes savings only when it has value

Our screening model caps usable solar against your entered consumption and self-use assumption. It values surplus at zero. That keeps the starting case from relying on an unconfirmed export payment. A detailed proposal still needs to compare the timing of production with your guesthouse’s demand.

Ask for a clear split between expected generation, electricity used on site, surplus and net savings after the stated operating allowance. Also ask what the estimate excludes: storage, backup capability, export income and future price changes should never be left implicit.

Sources & further reading

Primary references checked on 1 October 2026. International guidance supports the general principles; site design, service terms and Maldives connection requirements need local confirmation.